エタノール沈殿、エタノール沈澱、エタ沈

関: EtOH ppt、precipitate with ethanol

WordNet

the falling to earth of any form of water (rain or snow or hail or sleet or mist) (同)downfall
the process of forming a chemical precipitate
the quantity of water falling to earth at a specific place within a specified period of time; "the storm brought several inches of precipitation"
an unexpected acceleration or hastening; "he is responsible for the precipitation of his own demise"
the act of casting down or falling headlong from a height

PrepTutorEJDIC

〈U〉突然の大あわて / 〈C〉〈U〉(化学で)沈殿物;〈U〉沈殿 / 〈U〉降雨,降雪;降雨量,降雪量
=alcohol

Wikipedia preview

出典(authority):フリー百科事典『ウィキペディア（Wikipedia）』「2012/12/20 12:03:41」(JST)

wiki en

[Wiki en表示]

Ethanol precipitation is a method used to purify and/or concentrate RNA, DNA and polysaccharides such as pectin and xyloglucan from aqueous solutions.

DNA Precipitation

Theory

The first hydration shell of a sodium ion dissolved in water

DNA is polar due to its highly charged phosphate backbone. This polarity, based on the principle of "like dissolves like", makes it soluble in water, which is also highly polar.

The high polarity of water, reflected by the high value of its dielectric constant 80.1 (at 20 °C), means that the electrical force between any two charges in aqueous solution is highly diminished compared to the force in a vacuum or air.

This relation is reflected in Coulomb's law, which can be used to calculate the force acting on two charges and separated by a distance by using the dielectric constant (also called relative static permittivity) of the medium in the denominator of the equation ( is an electric constant):

At an atomic level, the diminishment of force acting on charges results from water molecules forming hydration shells around them. It makes water a very good solvent for charged compounds like salts. Electric force which normally holds salt crystals together by way of ionic bonds is weakened in the presence of water allowing ions to separate from the crystal and spread through solution.

The same mechanism operates in the case of negatively charged phosphate groups on a DNA backbone: even if positive ions are present in solution, the relatively weak electric force prevents them from forming stable ionic bonds with phosphates and precipitating out of solution.

Ethanol is much less polar than water; its dielectric constant is 24.3 (at 25 °C). This means that adding ethanol to solution disrupts the screening of charges by water. If enough ethanol is added, the electrical attraction between phosphate groups and any positive ions present in solution becomes strong enough to form stable ionic bonds and DNA precipitation. This usually happens when ethanol composes over 64% of the solution. As the mechanism suggests, the solution has to contain positive ions for precipitation to occur; usually Na⁺, NH₄⁺ or Li⁺ play this role .^[1]

Practice

A laboratory tabletop centrifuge

DNA is precipitated by first ensuring that the correct concentration of positive ions is present in solution (too much will result in a lot of salt co-precipitating with DNA, too little will result in incomplete DNA recovery) and then adding two to three volumes of at least 95% ethanol. Many protocols advise storing DNA at low temperature at this point but this has been shown to lower precipitation efficiency.^[2]^[3] The best efficiency is achieved at room temperature but when possible degradation is taken into account it is probably best to incubate DNA on wet ice. Optimal incubation time depends on the length and concentration of DNA. Smaller fragments and lower concentrations will require longer times to achieve the same recovery. For very small lengths and low concentrations over-night incubation is recommended. In such cases use of carriers like tRNA, glycogen or linear polyacrylamide can greatly improve recovery.

During incubation DNA and some salts will precipitate from solution, in the next step this precipitate is collected by centrifugation in a microcentrifuge tube at high speeds (~12,000g). Time and speed of centrifugation has the biggest effect on DNA recovery rates. Again smaller fragments and higher dilutions require longer and faster centrifugation. Centrifugation can be done either at room temperature or in 4 °C or 0 °C. During centrifugation precipitated DNA has to move through ethanol solution to the bottom of the tube, lower temperatures increase viscosity of the solution and larger volumes make the distance longer, so both those factors lower efficiency of this process requiring longer centrifugation for the same effect.^[2]^[3] After centrifugation the supernatant solution is removed, leaving a pellet of crude DNA. Whether the pellet is visible depends on the amount of DNA and on its purity (dirtier pellets are easier to see) or the use of co-precipitants.

In the next step, 70% ethanol is added to the pellet, and it is gently mixed to break the pellet loose and wash it. This removes some of the salts present in the leftover supernatant and bound to DNA pellet making the final DNA cleaner. This suspension is centrifuged again to once again pellet DNA and the supernatant solution is removed. This step is repeated once.

Finally, the pellet is air-dried and the DNA is resuspended in water or other desired buffer. It is important not to over-dry the pellet as it may lead to denaturation of DNA and make it harder to resuspend.

Isopropanol can also be used instead of ethanol; the precipitation efficiency of the isopropanol is higher making one volume enough for precipitation. However, isopropanol is less volatile than ethanol and needs more time to air-dry in the final step. The pellet might also adhere less tightly to the tube when using isopropanol.^[1]

Protocol

Add 1/10 volume of Sodium Acetate (3 M, pH 5.2).
Add 2.5–3.0 X volume (calculated after addition of sodium acetate) of at least 95% ethanol.
Incubate on ice for 15 minutes. In case of small DNA fragments or high dilutions overnight incubation gives best results, incubation below 0 °C does not significantly improve efficiency.^[2]^[3]
Centrifuge at > 14,000 x g for 30 minutes at room temperature or 4 °C.
Discard supernatant being careful not to throw out DNA pellet which may or may not be visible.
Rinse with 70% Ethanol
Centrifuge again for 15 minutes.
Discard supernatant and dissolve pellet in desired buffer. Make sure the buffer comes into contact with the whole surface of the tube since a significant portion of DNA may be deposited on the walls instead of in the pellet.^[1]

References

^ ^a ^b ^c Molecular Cloning: A Laboratory Manual (Third Edition) by Joseph Sambrook, Peter MacCallum Cancer Institute, Melbourne, Australia; David Russell, University of Texas Southwestern Medical Center, Dallas
^ ^a ^b ^c Zeugin JA, Hartley JL (1985). "Ethanol Precipitation of DNA". Focus 7 (4): 1–2. http://www.invitrogen.com/etc/medialib/en/filelibrary/pdf/focus.Par.56415.File.dat/Focus%20Volume%207%20Issue%204.PDF. Retrieved 2008-09-10.
^ ^a ^b ^c Crouse J, Amorese D (1987). "Ethanol Precipitation: Ammonium Acetate as an Alternative to Sodium Acetate". Focus 9 (2): 3–5. http://www.invitrogen.com/etc/medialib/en/filelibrary/pdf/focus.Par.34900.File.dat/Focus%20Voume%209%20Issue%202.pdf. Retrieved 2008-09-10.

External links

bitesizebio.com The Basics: How Ethanol Precipitation of DNA and RNA Works
Zeugin JA, Hartley JL (1985). "Ethanol Precipitation of DNA". Focus 7 (4): 1–2. http://www.invitrogen.com/etc/medialib/en/filelibrary/pdf/focus.Par.56415.File.dat/Focus%20Volume%207%20Issue%204.PDF. Retrieved 2008-09-10.
Crouse J, Amorese D (1987). "Ethanol Precipitation: Ammonium Acetate as an Alternative to Sodium Acetate". Focus 9 (2): 3–5. http://www.invitrogen.com/etc/medialib/en/filelibrary/pdf/focus.Par.34900.File.dat/Focus%20Voume%209%20Issue%202.pdf. Retrieved 2008-09-10.

UpToDate Contents

全文を閲覧するには購読必要です。 To read the full text you will need to subscribe.

1. 小児におけるエタノール中毒：疫学、毒性の推定、および毒性作用 ethanol intoxication in children epidemiology estimation of toxicity and toxic effects
2. 成人におけるエタノール中毒 ethanol intoxication in adults
3. 小児におけるエタノール中毒：臨床的特徴、評価、およびマネージメント ethanol intoxication in children clinical features evaluation and management
4. 限局性肝細胞癌に対する非外科的治療：ラジオ波焼灼術、経皮的エタノール注射、熱凝固療法、および凍結融解壊死療法 nonsurgical therapies for localized hepatocellular carcinoma radiofrequency ablation percutaneous ethanol injection thermal ablation and cryoablation
5. 免疫グロブリンの静脈内投与：副作用 intravenous immune globulin adverse effects

English Journal

Improved homopolymer separation to enable the application of (1)H NMR and HPLC for the determination of the reaction parameters of the graft copolymerization of acrylic acid onto starch.

Witono JR, Marsman JH, Noordergraaf IW, Heeres HJ, Janssen LP.SourceChemical Engineering Department, Parahyangan Catholic University, Jl. Ciumbuleuit No. 94, Bandung 40164, Indonesia. Electronic address: judy@unpar.ac.id.
Carbohydrate research.Carbohydr Res.2013 Apr 5;370:38-45. doi: 10.1016/j.carres.2013.01.017. Epub 2013 Jan 31.
Graft copolymers of starch with acrylic acid are a promising green, bio based material with many potential applications. The grafting of acrylic acid onto cassava starch in an aqueous medium initiated by Fenton's reagent has been studied. Common grafting result parameters are add-on (yield) and graf
PMID 23435285

Solution equilibrium behind the room-temperature synthesis of nanocrystalline titanium dioxide.

Seisenbaeva GA, Daniel G, Nedelec JM, Kessler VG.SourceDepartment of Chemistry, Biocenter, Swedish University of Agricultural Sciences (SLU), Box 7015, SE-75007, Uppsala, Sweden. gulaim.seisenbaeva@slu.se vadim.kessler@slu.se.
Nanoscale.Nanoscale.2013 Mar 6. [Epub ahead of print]
Formation of nanocrystalline and monodisperse TiO2 from a water soluble and stable precursor, ammonium oxo-lactato-titanate, (NH4)8Ti4O4(Lactate)8·4H2O, often referred to as TiBALDH or TALH, is demonstrated to be due to a coordination equilibrium. This compound, individual in the solid state, exist
PMID 23467564

Japanese Journal

日本及び米国の健康食品に配合されたコンドロイチン硫酸の品質評価

戸井田敏彦
日本食品化学学会誌 18(1), 35-42, 2011-04-26
… In order to evaluate the quality of CS in Japanese health foods, the origin and content of CS were investigated using health foods of great sales volume in Japanese and US markets by three methods: a) conducting disaccharide compositional analysis after enzymatic depolymerization, b) molecular weight determination using gel permeation chromatography, c) purification of CS in the products by ethanol precipitation and by complex formation with cetylpyridinium chloride. …
NAID 110008661325

P-52 超臨界水ガス化パイロットプラントにおける無機固形物が機器圧力損失に与える影響(ポスターセッション2:技術10,研究発表(ポスター発表))

中村昭史,清水嘉久,山村幸政,山崎寿樹,尾山圭二,内山一郎,藤井幹人,美濃輪智朗,川井良文,野口琢史,野田洋二,Promdej Chutinan,松村幸彦
バイオマス科学会議発表論文集 (6), 156-157, 2011-01-12
… To clarify the effects of inorganic material in the feedstock on the pressure loss of super critical water gasification(SCWG) equipment, SCWG tests of ethanol etc. … As a result, it was considered that the main cause of increasment of pressue loss is precipitation of the inorganic material in the feedstock. …
NAID 110008463479

Related Pictures

★リンクテーブル★

リンク元	「エタノール沈殿」「エタ沈」「EtOH ppt」「precipitate with ethanol」「エタノール沈澱」
関連記事	「precipitation」

「エタノール沈殿」

　　[★]

英: ethanol precipitation、EtOH ppt、precipitate with ethanol
関: エタ沈、エタノール沈澱

伝統的なプロトコール

x ul of DNA soln.

add 1/10 volume of 3M NaOAc
add 2.5 volume of 100% EtOH
mix well
cfg. max speed for 20? min at 4C ?
ppt
add 100? ul of 70% EtOH
cfg. max speed for 10? min at 4C ?
ppt
dry up
add 20 ul of TE and dissolve