WordNet

a state of uncertainty about what should be done (usually following some important event) preceding the establishment of a new direction of action; "the flux following the death of the emperor" (同)state of flux
a substance added to molten metals to bond with impurities that can then be readily removed
excessive discharge of liquid from a cavity or organ (as in watery diarrhea)
the rate of flow of energy or particles across a given surface
in constant change; "his opinions are in flux"; "the newness and flux of the computer industry"
a flow or discharge (同)fluxion
(of a situation) exceptionally tense; "an atmosphere electric with suspicion"
a car that is powered by electricity (同)electric automobile, electric car
using or providing or producing or transmitting or operated by electricity; "electric current"; "electric wiring"; "electrical appliances"; "an electrical storm" (同)electrical
affected by emotion as if by electricity; thrilling; "gave an electric reading of the play"; "the new leader had a galvanic effect on morale" (同)galvanic, galvanizing, galvanising
the amount per unit size (同)denseness
(physics) the number of changes in energy flow across a given surface per unit area (同)flux

PrepTutorEJDIC

流動,流れ;上げ潮 / 絶え間ない変化,流転(るてん) / 融剤,フラックス / (流体・粒子・エネルギーの)流量,流束,流動率 / (電気・磁気の)束(そく) / (体内の液体の)異常流出,異常排出
《名詞の前にのみ用いて》『電気の』;電気が引き起こす / 《名詞の前にのみ用いて》電気で動く,電動の;電気を起こす,発電の / 興奮させる,はらはら(ぞくぞく)させる
〈U〉『密集』;『密度』,濃さ / 〈U〉〈C〉(物質の)密度,濃度,比重 / 〈U〉《話》頭の鈍さ,愚鈍さ
インフルエンザ,流感

Wikipedia preview

出典(authority):フリー百科事典『ウィキペディア（Wikipedia）』「2015/11/12 00:14:02」(JST)

wiki en

[Wiki en表示]

In physics, the electric displacement field, denoted by D, is a vector field that appears in Maxwell's equations. It accounts for the effects of free and bound charge within materials. "D" stands for "displacement", as in the related concept of displacement current in dielectrics. In free space, the electric displacement field is equivalent to flux density, a concept that lends understanding to Gauss's law. It has the SI units of coulomb per squared metre (C m⁻²).

Definition

In a dielectric material the presence of an electric field E causes the bound charges in the material (atomic nuclei and their electrons) to slightly separate, inducing a local electric dipole moment. The electric displacement field D is defined as

where is the vacuum permittivity (also called permittivity of free space), and P is the (macroscopic) density of the permanent and induced electric dipole moments in the material, called the polarization density. Separating the total volume charge density into free and bound charges:

the density can be rewritten as a function of the polarization P:

The polarization P is defined to be a vector field whose divergence yields the density of bound charges ρ_b in the material. The electric field satisfies the equation:

and hence

.

The displacement field therefore satisfies Gauss's law in a dielectric:

.

However, electrostatic forces on ions or electrons in the material are still governed by the electric field E in the material via the Lorentz Force. It should also be remembered that D is not determined exclusively by the free charge. Consider the relationship:

which, by the fact that E has a curl of zero in electrostatic situations, evaluates to:

The effect of this equation can be seen in the case of an object with a "frozen in" polarization like a bar electret, the electric analogue to a bar magnet. There is no free charge in such a material, but the inherent polarization gives rise to an electric field. If the wayward student were to assume that the D field were entirely determined by the free charge, he or she would conclude that the electric field were zero outside such a material, but this is patently not true. The electric field can be properly determined by using the above relation along with other boundary conditions on the polarization density to yield the bound charges, which will, in turn, yield the electric field.

In a linear, homogeneous, isotropic dielectric with instantaneous response to changes in the electric field, P depends linearly on the electric field,

where the constant of proportionality is called the electric susceptibility of the material. Thus

where ε = ε₀ ε_r is the permittivity, and ε_r = 1 + χ the relative permittivity of the material.

In linear, homogeneous, isotropic media, ε is a constant. However, in linear anisotropic media it is a tensor, and in nonhomogeneous media it is a function of position inside the medium. It may also depend upon the electric field (nonlinear materials) and have a time dependent response. Explicit time dependence can arise if the materials are physically moving or changing in time (e.g. reflections off a moving interface give rise to Doppler shifts). A different form of time dependence can arise in a time-invariant medium, in that there can be a time delay between the imposition of the electric field and the resulting polarization of the material. In this case, P is a convolution of the impulse response susceptibility χ and the electric field E. Such a convolution takes on a simpler form in the frequency domain—by Fourier transforming the relationship and applying the convolution theorem, one obtains the following relation for a linear time-invariant medium:

where is the frequency of the applied field. The constraint of causality leads to the Kramers–Kronig relations, which place limitations upon the form of the frequency dependence. The phenomenon of a frequency-dependent permittivity is an example of material dispersion. In fact, all physical materials have some material dispersion because they cannot respond instantaneously to applied fields, but for many problems (those concerned with a narrow enough bandwidth) the frequency-dependence of ε can be neglected.

At a boundary, , where σ_f is the free charge density and the unit normal points in the direction from medium 2 to medium 1.^[1]

History

Recall that Gauss's law was formulated by Carl Friedrich Gauss in 1835, but was not published until 1867. This places a lower limit on the year of the formulation and use of D to not earlier than 1835. Again, considering the law in its usual form using E vector rather than D vector, it can be safely said that D formalism was not used earlier than 1860s.

The Electric Displacement field was first found to be used in the year 1864 by James Clerk Maxwell, in his paper A Dynamical Theory of the Electromagnetic Field. Maxwell used calculus to exhibit Michael Faraday's theory, that light is an electromagnetic phenomenon. In PART V. — THEORY OF CONDENSERS, Maxwell introduced the term D in page 494, titled, Specific Capacity of Electric Induction (D), explained in a form different from the modern and familiar notations.

Confusion over the term "Maxwell's equations" arises because it has been used for a set of eight equations that appeared in Part III of Maxwell's 1864 paper A Dynamical Theory of the Electromagnetic Field, entitled "General Equations of the Electromagnetic Field", and this confusion is compounded by the writing of six of those eight equations as three separate equations (one for each of the Cartesian axes), resulting in twenty equations and twenty unknowns. (As noted above, this terminology is not common: Modern references to the term "Maxwell's equations" refer to the Heaviside restatements.)

It was Oliver Heaviside who reformulated the complicated Maxwell's equations to the modern, elegant form that we know today. But it wasn't until 1884 that Heaviside, concurrently with similar work by Willard Gibbs and Heinrich Hertz, grouped them together into a distinct set. This group of four equations was known variously as the Hertz–Heaviside equations and the Maxwell–Hertz equations, and are sometimes still known as the Maxwell–Heaviside equations.

Hence, it was probably Heaviside who lent D the present significance it now has.^[2]

Example: Displacement field in a capacitor

A parallel plate capacitor. Using an imaginary pillbox, it is possible to use Gauss's law to explain the relationship between electric displacement and free charge.

Consider an infinite parallel plate capacitor placed in space (or in a medium) with no free charges present except on the capacitor. In SI units, the charge density on the plates is equal to the value of the D field between the plates. This follows directly from Gauss's law, by integrating over a small rectangular pillbox straddling one plate of the capacitor:

On the sides of the pillbox, dA is perpendicular to the field, so that part of the integral is zero, leaving, for the space inside the capacitor where the fields of the two plates add,

,

where A is surface area of the top face of the small rectangular pillbox and Q_free / A is just the free surface charge density on the positive plate. Outside the capacitor, the fields of the two plates cancel each other and |E| = |D| = 0. If the space between the capacitor plates is filled with a linear homogeneous isotropic dielectric with permittivity ε, the total electric field E between the plates will be smaller than D by a factor of ε: |E| = Q_free / (εA).

If the distance d between the plates of a finite parallel plate capacitor is much smaller than its lateral dimensions we can approximate it using the infinite case and obtain its capacitance as

where V is the potential difference sustained between the two plates. The partial cancellation of fields in the dielectric allows a larger amount of free charge to dwell on the two plates of the capacitor per unit potential drop than would be possible if the plates were separated by vacuum.

References

^ David Griffiths. Introduction to Electrodynamics (3rd 1999 ed.).
^ History of Maxwell's equations#The term Maxwell's equations

"electric displacement field" at PhysicsForums

UpToDate Contents

全文を閲覧するには購読必要です。 To read the full text you will need to subscribe.

1. リポ蛋白の分類、代謝、およびアテローム性動脈硬化症における役割 lipoprotein classification metabolism and role in atherosclerosis
2. 女性における乳癌リスクに影響を与える因子 factors that modify breast cancer risk in women
3. LDLコレステロール代謝の遺伝性疾患 inherited disorders of ldl cholesterol metabolism
4. 低比重リポタンパク（LDL-C）上昇に対する予防的初期マネージメント management of elevated low density lipoprotein cholesterol ldl c in primary prevention
5. 乳腺濃度と乳癌スクリーニング breast density and screening for breast cancer

English Journal

Assessment of exposure to MRI motion-induced fields based on the International Commission on Non-Ionizing Radiation Protection (ICNIRP) guidelines.

Zilberti L1, Bottauscio O1, Chiampi M2.
Magnetic resonance in medicine.Magn Reson Med.2015 Nov 3. doi: 10.1002/mrm.26031. [Epub ahead of print]
PURPOSE: The goal of this study was to conduct an exposure assessment for workers moving through the stray stationary field of common MRI scanners, performed according to the recent International Commission on Non-Ionizing Radiation Protection (ICNIRP) Guidelines, which aim at avoiding annoying sens
PMID 26525160

Computational Study Toward Deep Transcranial Magnetic Stimulation Using Coaxial Circular Coils.

Lu M, Ueno S.
IEEE transactions on bio-medical engineering.IEEE Trans Biomed Eng.2015 Jul 2. [Epub ahead of print]
To investigate the possibility for stimulating deeper brain regions whilst decreasing the electrical field in superficial cortical regions by employing coaxial circular coils.METHODS: The Halo coil, Halo-circular assembly coil (HCA coil) and Halo coil working with two circular coils (HTC coil) were
PMID 26151931

Analysis of Transcranial Magnetic Stimulation Based on the Surface Integral Equation Formulation.

Cvetković M, Poljak D, Haueisen J.
IEEE transactions on bio-medical engineering.IEEE Trans Biomed Eng.2015 Jun;62(6):1535-45. doi: 10.1109/TBME.2015.2393557. Epub 2015 Jan 16.
GOAL: The aim of this paper is to provide a rigorous model and, hence, a more accurate description of the transcranial magnetic stimulation (TMS) induced fields and currents, respectively, by taking into account the inductive and capacitive effects, as well as the propagation effects, often being ne
PMID 25608302